MCP2515-I/P CANbus Controller CAN 2.0 SPI Interface 18-PDIP
Stok Kodu
265.01.06
114,74 TL
MCP2515
Stand-Alone CAN Controller With SPI Interface
• Implements CAN V2.0B at 1 Mb/s:
- 0 – 8 byte length in the data field
- Standard and extended data and remote frames
• Receive buffers, masks and filters:
- Two receive buffers with prioritized message storage
- Six 29-bit filters
- Two 29-bit masks
• Data byte filtering on the first two data bytes
(applies to standard data frames)
• Three transmit buffers with prioritizaton and abort features
• High-speed SPI Interface (10 MHz):
- SPI modes 0,0 and 1,1
• One-shot mode ensures message transmission is
attempted only one time
• Clock out pin with programmable prescaler:
- Can be used as a clock source for other device(s)
• Start-of-Frame (SOF) signal is available for monitoring the SOF signal:
- Can be used for time-slot-based protocols
and/or bus diagnostics to detect early bus degredation
• Interrupt output pin with selectable enables
• Buffer Full output pins configurable as:
- Interrupt output for each receive buffer
- General purpose output
• Request-to-Send (RTS) input pins individually
configurable as:
- Control pins to request transmission for each transmit buffer
- General purpose inputs
• Low-power CMOS technology:
- Operates from 2.7V – 5.5V
- 5 mA active current (typical)
- 1 μA standby current (typical) (Sleep mode)
• Temperature ranges supported:
- Industrial (I): -40°C to +85°C
- Extended (E): -40°C to +125°C
Bu ürüne ilk yorumu siz yapın! LÜTFEN Sorularınızı bu alana yazmayınız. Sorularınız için info@elektrovadi.com