VmodCAM - Stereo Camera Module
Stok Kodu
73.02.04.01
8.633,77 TL
VmodCAM
Stereo Kamera Modülü
|
IC: |
2x Aptina MT9D112 |
|
Connector(s): |
VHDCI |
- •Two independent Aptina MT9D112 2-megapixel CMOS digital image sensors
•1600x1200 maximum resolution at 15 FPS
•63mm inter-camera spacing (stereo baseline)
•10-bit raw color depth
•I2C control bus
•Bayer, RGB, YCrCb output formats
•Automatic exposure, gain, and white balance
•Powerful image correction algorithms
•Image scaling
•Output FIFO
•68-pin female VHDCI connector
The VmodCAM board provides digital imaging capabilities for any Digilent FPGA system board with a VHDCI connector. It features two Aptina MT9D112 2-megapixel CMOS digital image sensors. The sensors can provide frame rates from 15 FPS upwards, depending on the resolution.
Its system-on-a-chip design integrates an image flow processor and enables selectable output formats, scaling, and special effects. The integrated PLL (phase-locked loop) and microprocessor offer a flexible serial control interface. The output data is sent on a parallel bus in processed YCrCb, RGB, or raw Bayer formats.
The two MT9D112 cameras can be controlled independently and can acquire two separate, simultaneous image feeds. They are controlled by a two-wire interface. Each camera has a 2 megapixel color sensor array in Bayer color filter arrangement. The sensor readout is 10-bit and supports skipping or binning rows/columns.
NOTE: To connect to a system board, this product requires a male-to-male VHDCI cable, which is not included.
Bu ürüne ilk yorumu siz yapın! LÜTFEN Sorularınızı bu alana yazmayınız. Sorularınız için info@elektrovadi.com
Tavsiye Ürünler
962,80 TL + KDV
KDV dahil 1.155,36 TL